SEREN R301 Operator's Manual download pdf (Page 76)

RX01/LX01 SERIES RF POWER SUPPLY OPERATOR’S MANUAL

PROGRAMMABLE PARAMETER DETAILS

PARAMETER PARAMETER DETAIL APPLIES TO

power metering resolution.

Factory default setting: HIGH RANGE

Exciter Mode

(Frequency Source)

Select:

EXCITER- MASTER: The unit uses its internal frequency source

to generate the RF output signal. In “master” mode, the internal

frequency source is available at the CEX OUT connector on the

rear panel.

EXCITER- SLAVE: The unit uses the rear panel CEX IN signal

as the frequency source for the RF output signal. “Slave” Mode is

used in systems with multiple RF power supplies; with one RF

power supply as the master and the other power supplies operating

as “slaves”. This configuration is used to keep the power supplies

synchronized, thus preventing or minimizing RF circulating

currents within the processing system. In “slave” mode, the CEX

IN signal is routed to the rear panel CEX OUT connector.

Factory default setting: EXCITER - MASTER

All

Maximum Output

Power:

Allows the user limit the maximum RF output power. Limit is

adjustable between 1 Watt and rated output power, in 1-Watt

increments. When the output power setpoint is equal to the MAX

POWER value, “MAX” is indicated on the front panel display,

line 2, right-hand side.

Factory default setting: Rated Output Power.

All

Source Menu

Enable/Disable

Enables display of the Source Parameter menu options. When set

to “ON”, the Source Parameters are displayed as the next steps in

the menu. Users may scroll the source parameters with the menu

UP/DOWN buttons and adjustments to the settings may be

preformed. When set to “OFF”, the Source Parameters are not

displayed and pressing the menu UP/DOWN buttons skips over

the source parameters.

The Source Parameters do not have any direct effect on the

operation or performance of the RF Power Supply. The Source

Parameter data is stored within the unit’s non-volatile memory, for

retrieval by commands sent to the unit via the serial interface.

Refer to the Serial Interface Operation section for serial command

details.

Factory default setting: SOURCE MENU ENABLED

Custom OEM

Configurations

Start Power Parameter Start Power recallable parameter. Variable, 1W to rated output

power, in 1-Watt increments.

Use the serial command “CGP?” to read the current parameter

value. Refer to the Serial Commands section for a detailed

explanation of the “CGP?” command.

Related menu item: Source Menu Enable/Disable

Factory default setting: 80W

Custom OEM

Configurations

Idle Power Parameter Idle Power recallable parameter. Variable, 1W to rated output

Custom OEM

Page 68

Seren IPS Inc.

6100220000 Rev. 1.09

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 209 210

Comments to this Manuals

No comments

SEREN R301 Operator's Manual Page 76

Comments to this Manuals