SEREN R301 Operator's Manual download pdf (Page 71)

RX01/LX01 SERIES RF POWER SUPPLY OPERATOR’S MANUAL

PROGRAMMABLE PARAMETER DETAILS

PARAMETER PARAMETER DETAIL APPLIES TO

Control Source: Selects the interface used as the control source for the RF power

supply.

Factory default setting: PANEL

All

Panel Control Selects the front panel keypad as the control source. RF ON/OFF

and power setpoint commands from the analog interface are

ignored. Serial interface commands, with the exception of the

“SERIAL” command, are ignored.

Line 2 of the front panel display shows “PANEL” as the control

source.

All

Analog Control Selects the analog interface as the control source. Front panel RF

ON and power setpoint commands are ignored. Serial commands,

with the exception of the “SERIAL” command, are ignored.

Note:

The front panel RF ON/OFF button can disable the RF

output.

Line 2 of the front panel display shows “ANALOG” as the control

source.

All

Serial Control Selects the serial interface as the control source. Front panel RF

ON and power setpoint commands are ignored. RF ON/OFF and

power setpoint commands from the analog interface are ignored.

Note:

The front panel RF ON/OFF button can disable the RF

output.

Selecting Serial Control enables access to the serial interface

parameters.

Line 2 of the front panel display shows “SERIAL” as the control

source.

All

Serial Interface

Protocol:

Selects the serial interface protocol. RS-232, RS-422, RS-485 4-

Wire, RS-485 2-Wire, MODBUS 2-Wire (2W), or MODBUS 4-

Wire (4W) may be selected.

When RS-485, RS-422, or MODBUS is selected, access to the

serial address parameter is enabled.

Factory default setting: RS-232.

All

Serial Address Selects the serial address for RS-422, RS-485, and MODBUS

serial communication protocols.

RS-422, RS-485 Address range: 00 to 99

MODBUS Address range: 1 to 247

Note: For RS-232 operation, the Serial Address must be set to

“99”

Factory default setting: 99

All

Serial Baud Rate: Selects 2400, 4800, 9600, 19200, 38400, 57600, or 115200 Baud.

Other serial communication parameters are not configurable.

Parity: None; Data bits: 8; Stop Bits: 1; Handshaking: None

Factory default setting: 19200 BAUD

All

Page 63

Seren IPS Inc.

6100220000 Rev. 1.09

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 209 210

Comments to this Manuals

No comments

SEREN R301 Operator's Manual Page 71

Comments to this Manuals