SEREN R301 Operator's Manual download pdf (Page 9)

RX01/LX01 SERIES RF POWER SUPPLY OPERATOR’S MANUAL

Safety Notes

POINT

EQUIPOTENTIAL BONDING

GROUND

PROTECTIVE

= CAUTION

HIGH

VOLTAGE

RADIO FREQUENCY

ENERGY HAZARD

Seren IPS Inc. RF Power Supplies have been designed and tested to meet strict safety

requirements. These include independent lab examination and approval, and compliance to

established standards. Please read the following instructions carefully before operating the RF

Power Supply and refer to them as needed to ensure the continued safe operation of the RF

Power Supply.

Follow all warnings and instructions marked on or supplied with the product.

Symbology:

Unplug or disconnect this equipment from the power source before cleaning or re-configuring

the AC mains voltage.

Do not use this equipment near water, wet locations, or outdoors.

Do not place this equipment on an unstable cart, stand, or table. The RF Power Supply may fall,

causing personal injury or damage to the RF Power Supply.

This product is equipped with a power cord and grounding type plug. This is a safety feature.

To avoid electric shock, this unit must be connected to the power source in compliance with the

National Electrical Code ANSI C1 and/or any other codes applicable to the user. Improper

installation may result in a shock or fire hazard.

It is the responsibility of the installer to provide a proper protective ground from the RF Power

Supply to earth ground, in accordance with local and national electrical codes, and any other

codes applicable to the user.

The RF Power Supply should be operated from the type of power source indicated by the ratings

plate. If you are not sure of the type of power available, consult an electrician or your local

power company.

The power supply cord and plug is the disconnect device for this equipment. If the plug is

removed from the cord and the power cord is hard wired to the power source, it is the

responsibility of the installer to provide a disconnect device.

Do not allow anything to rest on the power cord or interconnecting cables. Do not locate the RF

Power Supply where persons will step on the power or interconnecting cables.

Slots and Openings in the equipment’s chassis are provided for ventilation. To ensure reliable

operation of the RF Power Supply, these openings must not be blocked, covered, or restricted.

Restricting the air inlets or exhaust will cause the unit to overheat. Sustained over temperature

conditions may degrade or damage the unit.

Page 1

Seren IPS Inc.

6100220000 Rev. 1.09

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 209 210

Comments to this Manuals

No comments

SEREN R301 Operator's Manual Page 9

Comments to this Manuals