SEREN R301 Operator's Manual download pdf (Page 29)

RX01/LX01 SERIES RF POWER SUPPLY OPERATOR’S MANUAL

SERIAL COMMAND REFERENCE

TO SEND DESCRIPTION/COMMENT Applies To

Assert PANEL control PANEL<cr> Sets the front panel as the control source.

Response: <cr>

All

Set the Operating

Frequency

XXX_FQ<cr> XXX is the operating frequency in KHz, 3

digits, 100-460KHz, 1 KHz increments

Response: <cr>

L-Series

Models

XXX_FQ<cr> XXX is the desired operating frequency,

1.70 to 2.10MHz in 10 KHz increments

(decimal is omitted)

Response: <cr>

1.7-2.1MHz

R-Series

Models

Set the Exciter Mode to

MASTER

MST<cr> Selects the RF Power Supply’s internal

frequency source.

Response: <cr>

All

Set the Exciter Mode to

SLAVE

SLV<cr> Selects the rear panel CEX IN connector as

the frequency source.

Response: <cr>

All

Select FORWARD

POWER leveling

DL<cr> Regulates the RF output level based solely

on the forward power feedback signal.

Response: <cr>

All

Select LOAD POWER

leveling

EL<cr> Regulates the RF output power based on the

net power delivered to the load. (forward

power – reflected power = net power)

Response: <cr>

All

Select POWER

CONTROL mode

IR<cr> Sets the unit’s internal power sensor as the

feedback source for regulating the RF

output level.

Response: <cr>

All

Select VOLTAGE

CONTROL mode

DR<cr> Sets the Analog Interface connector

FEEDBACK signal as the feedback source

for regulating the RF output level.

Response: <cr>

All

Set the Power Setpoint XXXXX_W<cr> XXXX is the desired power output, in

Watts. 1 to 5 digits.

Response: <cr>

All

Set the Power Setpoint

to 0 Watts and disable

RF output

WS<cr> Sets power setpoint to Zero (O) Watts and

Disable the RF output

Response: <cr>

All

Set the Power Setpoint

and enable

RF Output

XXXXX_WG<cr> XXXX is the desired power output, in

Watts. 1 to 5 digits.

Response: <prompt><cr>

All

Set the Voltage Setpoint XXXX_V<cr> XXXX is the desired output, in Volts. 1 to

4 digits.

All

Page 21

Seren IPS Inc.

6100220000 Rev. 1.09

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 209 210

Comments to this Manuals

No comments

SEREN R301 Operator's Manual Page 29

Comments to this Manuals