SEREN R301 Operator's Manual download pdf (Page 187)

RX01/LX01 SERIES RF POWER SUPPLY OPERATOR’S MANUAL

R10001 (27MHz) Specifications

Waste Heat into Coolant

Water

7000 Watts (398 BTU/minute) maximum.

Note: The waste heat does not peak at 8000 Watts

of output power - the waste heat peaks at 50% to

80% of full power or under certain reflected

power conditions.

Interlocks: External: External interlock provided for disabling RF

output power

Valve (optional): Prevents/disables RF Power output if external

water valve is missing or un plugged. (standard

units ignore this interlock – consult factory if

valve interlock is required)

Interface

Connections:

Analog Interface: 25 pin Female D-Sub Connector

Serial Interface:

9 pin Female D-Sub Connector

CEX Input: Female type BNC connector, 3 to 8V Peak-to-

Peak sine wave, 27.12MHz, 50 Ohms Nominal

Impedance

CEX Output: Female type BNC connector, 5 to 8V Peak-to-

Peak, 27.12MHz, into 50 Ohms

VALVE 4-Pin Male Disk-Drive Connector

Power

Monitor

Scaling:

Forward Power Monitor Monitor output is linearly proportional to 0 to

8000 Watts of forward power.

Output scaling is 5.0VDC at 8000 Watts

(0.625mV/Watt) or 10.0VDC at 8000 Watts

(1.25mV/Watt), depending on the analog voltage

range selected. (Default scaling)

Reflected Power Monitor Monitor output is linearly proportional to 0 to 800

Watts of reflected power.

Output scaling is 5.0VDC at 800 Watts

(6.25mV/Watt) or 10.0VDC at 800 Watts

(12.5mV/Watt), depending on the analog voltage

range selected. (Default scaling)

Page 179

Seren IPS Inc.

6100220000 Rev. 1.09

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 209 210

Comments to this Manuals

No comments

SEREN R301 Operator's Manual Page 187

Comments to this Manuals