SEREN R301 Operator's Manual download pdf (Page 20)

RX01/LX01 SERIES RF POWER SUPPLY OPERATOR’S MANUAL

Operation

Front panel operation of the RF Power Supply is simple. This section describes the use and

operation of the front panel controls in a “how to…” manner. Refer to the front panel illustration

on the previous page for item references.

Connect the RF Power Supply’s RF output to a 50-Ohm resistive load, Impedance

Matching network, processing system or other suitable load capable of handling

the unit’s full rated power output before

enabling AC mains Power.

Basic Front Panel Operation

Mains Power On/Off:

Press the POWER button (item 10) to enable mains power – the front panel display will

illuminate and momentarily display the firmware revision and copyright. Press the POWER

button again to disable mains power.

Control Source:

The control source is the control interface for the RF Power Supply. The RF Power Supply

has three (3) user-selectable control sources.

· The “PANEL” control source is for front panel operation of the RF Power Supply.

· The “ANALOG” control source is for controlling the RF Power Supply from the user’s

system, via the rear panel ANALOG INTERFACE connector.

· The “SERIAL” control source is used for controlling the RF Power Supply from a

computer or system controller, via an RS-232, RS-422, or RS-485 interface.

To select a control source, follow the directions below:

PANEL control:

To change the control source to the front panel,

1. Press the PGM button (Item 1) once (enter the programming menu).

2. Press the DOWN button (item 2) or the UP button (item 3) until line 3 of the display

shows the current control source (PANEL CONTROL, ANALOG CONTROL, or

SERIAL CONTROL).

3. Press the VALUE UP button (item 5) or the VALUE DOWN button (item 6) until

PANEL CONTROL is displayed on line 3.

4. Press the ENT button (item 5) to save the selection.

5. Press the RUN button (item 1) to exit the programming menu.

ANALOG control:

To change the control source to the Analog interface connector,

1. Press the PGM button (Item 1) once.

Page 12

Seren IPS Inc.

6100220000 Rev. 1.09

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 209 210

No comments

SEREN R301 Operator's Manual Page 20