SEREN R301 Operator's Manual download pdf (Page 94)

RX01/LX01 SERIES RF POWER SUPPLY OPERATOR’S MANUAL

8. Analog Interface Connector

The analog interface connector is located on the rear panel of the Radio Frequency Power

Supply. Control and status signals for the RF Power Supply are available on this

connector. See the table below for descriptions of the interface connector signals.

Connector type: 25-pin female “D” sub-miniature.

Interface cables for accessory products are available from Seren IPS Inc., authorized

Seren IPS representatives, and service depots. For assistance with system interfacing,

contact your system vendor, Seren IPS Customer Service, or a Seren IPS service

representative.

The RF Power Supply responds to input from the Analog Interface when ANALOG

control has been selected. The External Interlock (pins 2 and 15) signal is active

regardless of the selected control method.

Asterisk (*) denotes an active-low signal

The RLX01 Series power supplies use a common Analog Interface connector, but some

pin functions vary by model type. Where applicable, the variation in pin function has

been noted.

Page 86

Seren IPS Inc.

6100220000 Rev. 1.09

ANALOG INTERFACE

PIN 25

PIN13

PIN 14

PIN1

GND, GNDI, FWDRET, REFRET, FBRET, RFENABLED RET,

and SETRET signals must be referenced at the user’s system or the

unit will

not operate properly.

To prevent radio frequency interference and ensure proper operation o

the RF power Supply, foil-shielded cable is strongly recommended fo

making interface connections between the RF Power supply and system

or accessory equipment.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 209 210

No comments

SEREN R301 Operator's Manual Page 94